Heavy-gauge vapor barriers, sealed foundation vents, and a dedicated sump discharge line so your Arlington Heights, IL crawl space stops feeding moisture into the floor joists above it.
Arlington Heights, IL crawl spaces vary a lot in how they were originally built, and a liner that's correct for one home can be undersized for another depending on foot traffic and storage use. We size thickness to how the space is actually used.
Every crew member is trained specifically on liner installation, seam sealing, and vent encapsulation, not general basement work.
Our technicians carry encapsulation materials on the truck for most standard-size crawl spaces, cutting down on return visits.
No hourly billing — the number we quote is the number on the final invoice.
We measure relative humidity before and after installation to confirm the space is actually staying below the threshold where mold and wood rot take hold.
We scope every Crawl Space Encapsulation job in person before quoting it, since two properties with the same symptom rarely need the same fix.
Before any liner goes down, we pump out existing standing water and remove debris left behind by prior drainage failures.
We install heavy-duty liner rated for crawl space conditions, sealed at every seam and pier to stop ground moisture from reaching the floor joists.
Sealed vents are paired with mechanical dehumidification so the space doesn't just trap humidity instead of venting it.
We route discharge lines well away from the foundation so pumped water doesn't just cycle back in.
Exposed ductwork inside an unencapsulated crawl space collects condensation, which we address by insulating and sealing ducts while the space is open.
We ask about standing water, musty odor, and vent condition to gauge scope before scheduling the inspection.
A technician physically enters the space to check for standing water, existing liner condition, vent count, and duct exposure.
You'll see square footage, liner grade, vent sealing, and dehumidifier specs broken out in the written estimate.
Most residential encapsulations finish in one to two days depending on square footage and access.
"Our crawl space had standing water and a mold smell we couldn't get rid of no matter what we tried. Full encapsulation with a dehumidifier fixed it in one visit."
— Arlington Heights Homeowner
"Wood floors upstairs were starting to cup from crawl space humidity. Encapsulation plus a dehumidifier stopped it before we had to replace flooring."
— Arlington Heights Customer
"Access to our crawl space is tight and awkward, but the crew didn't seem bothered by it at all."
— Arlington Heights Homeowner
"Humidity reading before was over 80%. After encapsulation it's holding steady in the 50s."
— Arlington Heights Customer
We can scope either option depending on your budget and how severe the existing moisture problem is.
We'll recommend a thickness based on how the space is actually used, not just a default.
Some jurisdictions have code requirements around vent sealing, which we'll flag during the inspection if relevant.
If the smell persists after encapsulation, that usually points to a separate moisture source we'd need to investigate.
Yes — we extract existing water first, then proceed with liner and vent sealing once the space is dry enough to work safely.
Spaces with extensive prior water damage or debris may take longer — we'll give you a realistic estimate up front.
We encapsulate crawl spaces throughout Arlington Heights and the surrounding Arlington Heights, IL service area, including the zip codes listed below.
Zip codes we serve in Arlington Heights, IL: 60005 60004
Call now for a free inspection and a flat-rate quote before anything gets worse.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.
